JLG X14JH Operator Manual User Manual
Page 54
51
2.9.3 START OF THE ELECTRIC ENGINE
‑
Before starting the engine, make sure you know and have clear all the procedures descri‑
bed in the INSTRUCTING AND OPERATING MANUAL of the machine and you know
the meaning of the safety stickers.
‑
Read in the manual the recapitulatory table of the operator’s safety regulations and
apply all its prescriptions.
‑
Feed the machine with an electric cable by means of the clutch situated at the bottom on
the ground control support.
Before this:
‑
Make sure that the features of the electric lines match the voltage and the frequency indi‑
cated on the electric engine plate.
‑
Check the state of the electrical power wire and that its section must be suitable for
2.2kW. To connect use a “3x2.5mm2”three‑pole cable with type F47 earth plate, double
insulation with 16A plug. The maximum length of the cable must be 15 m.
‑
Fit in the ground a ground plate and connect it to the clamp of the machine earth plate,
or check the working order of the connecting net, in case the soil does not allow such
operation (e.g. inside premises).
‑
Before starting the engine, make sure that the selector on the control electric panel on the
control car (re: part.4 in fig.3) is positioned on the electric engine.
‑
Act on the green pushbutton on the control electric panel on the control car (re: part.2 in
fig.3).
THE ENGINE START MUST ALWAYS OCCUR WHEN ALL THE LEVERS OF THE CON‑
TROL DISTRIBUTORS ARE IN NEUTRAL.
Always check that there are no foreign elements (e.g. branches) activating accidentally a con‑
trol. This might move the platform suddenly independently from the operator’s will and
cause damages to things and/or people.
2.9.4 TRANSLATION
The machine is a self propelled machine able to move easily on any type of soils, able to
overcome big slopes (up to 18 degrees) and, seen the contained dimensions, to enter in nar‑
row places.To translate, it is absolutely necessary that the machine is closed and aligned. The
basket is the only control place planned by the manufacturer that prevents the operator from
accidents when doing the operations connected to the translation of the machine. In fact, the
controls have been designed to be used from that place in order to have a good sight of the
involved area.
BOOM LIFT MODELS X14JH
JLG
X14JHR0220311
ATTENZIONE
WARNING