AiM MyChron3 XG Log - Manual (Page 27)

To set the split’s number, after having entered the
CONFIGURATION MODE, push MENU/<< until you see
NUMBER OF SPLITS
Then push MEM/OK to enter EDIT MODE: use button
MENU/<< to change numbers and button >> to change digit.
The blinking number identifies the digit that can be edited.
Press button MEM/OK to save the changes or button VIEW to
discard the changes.
To set the Beacon obscuring time, after having entered the
CONFIGURATION MODE, push MENU/<< until you see
Obscuring time
Now push MEM/OK to enter EDIT MODE, then press button
MENU/<< until the correct number of splits appears on the
display’s lower right corner. The obscuring time can be set up
to a maximum value of 100 seconds.
Press button MEM/OK to save the changes or button VIEW to
discard the change
Distance and
total time
This function shows the total instrument working time (in hours
and minutes) and the distance covered by the vehicle (in km
or in miles) during a test.
To run this function press button MENU/<< until you see
TOTAL RUNNING
27