AiM MyChron3 XG Log - Manual (Page 53)

a. Control that the instrument is correctly plugged in the PC’s USB
port.
b. Verify that both PC and MyChron 3 Plus/Gold/Gold XG are
switched on.
c. If MyChron 3 Plus/Gold/Gold XG does not turn on, verify that
the external battery charge status is good.
d. If the instruments switches on but the automatic USB drivers
installation does not begin, try to plug the USB cable into another
USB port (if a second USB port is available).
e. If available, try to use another USB cable to plug MyChron 3
Plus/Gold/Gold XG in a PC’s USB port.
2. The automatic USB drivers installation starts but the USB driver is not
properly installed:
a. Control your PC’s Control Panel (click Start \ Settings \ Control
Panel \ System \ Device management): if you see a voice like
Unknown Peripheral or Unknown USB device with a yellow
question mark (or a red cross), please select that voice and
remove it (click the mouse right button and select the “Remove”
option). Then switch off your MyChron 3 Plus/Gold/Gold XG,
unplug the USB cable from the PC’s USB port, re-plug the USB
cable in the PC’s USB port and repeat the previously described
installation procedure.
53