AiM MyChron3 XG Log - Manual (Page 32)

Shift lights
configuration
This function allows the user to configure the 10 colored led
placed in the right upper part of the instrument’s display.
These led get switched on when the engine reaches a set
RPM value, indicating the pilot to shift gear.
To run this function, press button MENU/<< until you see
SHIFT LIGHT
By pressing button MEM/OK you will switch on the first led on
the left and the first one on the right, both green colored, and it
will appear the RPM value correspondent to that led lighting.
Press MEM/OK to enter EDIT MODE: use button MENU/<< to
change numbers and button >> to change digit. The blinking
digit identifies the digit that can be edited.
When the correct RPM value is displayed, press button
MEM/OK to save the changes and to step to second led
configuration; otherwise press button VIEW to quit without
saving.
The 10 led are colored in the following way: the first two on
the left and the first two on the right are green, the middle
ones are orange and the remaining ones led are red colored.
When the engine reaches the RPM value set for the 5
th
led, all
the 10 led will start flashing, advising the pilot to shift gear.
The RPM value can be set between 0 and 29999; if you set an
alarm value of 0, that led will be disabled.
32