AiM MyChron3 XG Log - Manual (Page 88)

o Press >> and repeat this procedure for all the gears.
o Once the last gear has been engaged, press button
MEM/OK.
o To restart calibration procedure, press button MENU/<<.
• If you have selected the “Gear computed” option follow this
procedure:
o Start for some “Learning laps”.
o During these laps, engage all gears.
o Stop the vehicle and turn off the engine in order to let the
gear calculation procedure start.
o If the calculated gears do not correspond to the engaged
ones, run another “learning lap”.
Setting the temperature alarms
• Select the “MAX/MIN TE1/TE2 Alarm” option.
• Press
MEM/OK to enter edit mode.
• Press MENU/<< until the correct number appears.
• Press >> to switch between digits.
• Press MEM/OK to save or VIEW to quit.
Shift lights configuration
• Select the “Shift light” option.
• Press
MEM/OK to enter edit mode.
• Press MENU/<< until the correct number appears.
• Press >> to switch between digits.
• Press MEM/OK to save and to configure the next led.
• Press VIEW to quit.
88