5 led table, 6 restore settings to default – AirLive Air3G User Manual
Page 20
2. Install the AIR3G
13
AirLive Air3G User’s Manual
2.5 LED Table
This section describes the LED behavior of Air3G. You can find the LED on the top side of
the Air3G.
WPS (Power)
Steady Blue – Normal Operation
Slow Flashing: WPS Surveying
OFF – No Power
WLAN
Slow Flashing : Radio is active
Fast Flashing: Transmitting Data
OFF: Radio Disabled
LAN1 ~4, WAN
Steady Blue : Link established
Fast Flashing: Transmitting Data
OFF: No Link
2.6 Restore Settings to Default
If you have forgotten your Air3G’s IP address or password, you can restore your Air3G to
the default settings by pressing on the “reset button” for more than 10 seconds. You might
need a pen or pencil for this operation. The reset button is inside the bottom case.
Please see diagram below for details.