Configuring the air3g, 1 important information, 2 prepare your pc – AirLive Air3G User Manual
Page 21: Important information, Prepare your pc
3. Configuring the Air3G
AirLive Air3G User’s Manual
14
The Air3G offers web browser (http) as management interface.
In this chapter, we will
explain Air3G’s management interface and how to get into them.
3.1 Important Information
The following information will help you to get start quickly. However, we recommend you
to read through the entire manual before you start. Please note the password and SSID
are case sensitive.
The default IP address is: 192.168.1.254 Subnet Mask: 255.255.255.0
The default Account is “admin”
The default Password is “airlive”
The default SSID is “airlive”
The default wireless mode is : 3G Router mode
Please remember to “Apply Change” for settings to be saved and take effect.
Please remember to “Reboot” the device after all settings are changed.
The Emergency Firmware Recovery only works when you connect to LAN1~4
By Default, the DHCP server is turned on in 3G Router mode. The other modes’
DHCP servers are turned off. Therefore, if you switch from 3G Router mode to
other modes, please remember to configure your PC’s IP address manually.
The default regulatory domain is “ETSI” for Europe. If you are not living in EU
countries, you might wish to change the regulatory domain. However, please do
not choose regulatory domain that does not apply to your country. Using wrong
regulatory domain might be illegal.
.
3.2 Prepare your PC
The Air3G can be managed remotely by a PC through either the wired or wireless network.
The default IP address of the Air3G is 192.168.1.254 with a subnet mask of 255.255.255.0.
This means the IP address of the PC should be in the range of 192.168.1.1` to
192.168.1.253.
3
3.
Configuring the Air3G