CCTV Camera Pros iDVR-PRO H Series DVRs - Manual (Page 10)

Overview
10 |
Overview
\ \ Change the remote control ID
The remote control will be active only if the remote control ID matches with that specified on the DVR.
If multiple DVRs are installed on one place and you have just a single remote control, use the ID button to set the remote
control ID. Only the ID-matching DVR can be controlled.
1. From <SYSTEM> - <CONTROL DEVICE> under the System Setup menu, set the <REMOTE CONTROLLER ID>
and press <APPLY>.
Select between 00 and 99. For more details, refer to <SYSTEM SETUP>.
2. Press the [ID] button on the remote control. The default remote control ID is 00.
3. Use the number buttons to provide a two-digit ID. If you want to enter 01, for instance, enter the number 0 and 1 in
sequence.
Check if the remote control ID is set properly by manipulating the remote control.
4. To reset the ID to 00, press and hold the [ID] button.