CCTV Camera Pros iDVR-PRO H Series DVRs - Manual (Page 39)

English | 39
5. Press the [EXIT] button on the remote control or
right-click any area to display the popup window as
in the right picture.
6. While the popup window is displayed, select
<Sensitivity> to set the motion detection sensitivity
of the channel currently selected.
i
Channel: Select the channel to set the motion
sensitivity.
- SENSITIVITY : 1(Low) ~ 30(High) - The higher
the number is, the more higher the sensitivity
level becomes.
i
DAYTIME : specify the time period that will be
considered as daytime.
- DAYTIME : specify the <SENSITIVITY> for the daytime.
- NIGHTTIME : specify the <SENSITIVITY> for the nighttime.
 Images recorded in a low contrast scene such as at night cause severe noise, triggering the motion event too often.
 If unwanted events occur frequently at night, you may want to reduce the motion sensitivity for the night duty.
\ \ PTZ Settings
You can configure PTZ cameras connected to each channel. Set the camera ID, protocol, baud rate and PTZ control
speed for each channel.
1. From <SYSTEM SETUP> - <CAMERA>, select
<PTZ SETUP>.
2. Use [ ▲▼◀▶ /ENTER] buttons of the remote control or
mouse to set protocol and bitrate of each channel.
 Refer to user
’
s manual of the camera or consult camera
installation service provider for further details on setting
the PTZ camera, such as camera address, protocol and
baud rate.
3. To apply your changes, click <APPLY> button.
4. Once the setup completed, press the [EXIT] button of
the remote control or click <CLOSE> button on the bottom to display a confirmation dialog.
Click <CANCEL> to return to the previous menu.
Sy
ste
m
S
ett
ing