CCTV Camera Pros iDVR-PRO H Series DVRs - Manual (Page 64)

System Setting
64 |
System Setting
\ \ Alarm Sensor
You can configure the settings of the alarm sensor and specify the operation of the sensor if an event occurs.
1. From <SYSTEM SETUP> - <EVENT>, select
<ALARM SENSOR>.
2. Use the [ ▲▼◀▶ ] buttons on the remote control or use the
mouse to specify the sensor input method and operation.
i
NAME : You can specify the name of the alarm
sensor.
i
OPERATION : You can specify the type of the
alarm sensor.
- N/O (Normal Open) : Normally the sensor is left
Open. If the sensor switches to Close, an event
will be triggered.
- N/C (Normal Close) : Normally the sensor is left
Close. If the sensor switches to Open, an event will be triggered.
i
LINKED CAMERA : Set the camera to sync with the alarm sensor if it is triggered.
If you have set the alarm recording and the sensor detects the recording, all synchronized cameras will start alarm
recording.
i
ALARM OUTPUT : Specify the alarm output channel if it is detected by the alarm sensor. The alarm will be output
to the specified channel.
i
PRESET : On alarm sensor ’ s detections, the camera moves as defined by the selected preset.
i
: Specify the output of the buzzer if an alarm is detected by the alarm sensor.
i
: Select to display the video popup if an alarm is detected by the alarm sensor.
If there exist multiple <LINKED CAMERA>, the video popup will be displayed in the maximum split mode.
i
: Select to display the OSD popup message if it is detected by the alarm sensor.
i
: Select to send an email if detected by the alarm sensor.
i
: Select whether to upload event notification onto the FTP upon detected alarm event.
3. To apply the change, click <APPLY> in the bottom of the screen.
4. When done, press the [EXIT] button on the remote control or click <CLOSE> in the lower screen. The confirmation
message appears and you will return to the previous menu.