ElmoMC ExtrIQ Gold Line Servo Drives-Gold Eagle - Manual (Page 29)

Gold Eagle Installation Guide
MAN-G-EAGIG-EC (Ver. 1.000)
||VL Logic Supply(P2)| www.elmomc.com
29
Table of Contents
9.7. VL Logic Supply(P2)
Connect the VL Logic power supply as described below.
To connect the VL Logic supply:
1.
Use a 24 – 26 AWG twisted pair shielded cable. The shield should have braid and Drain wire.
2. The source of the VL supply must be isolated from the Mains.
3. Before applying power, first verify that the polarity of the connection is correct.
Figure 13: VL Logic Supply Connection Diagram
9.7.1. VL Logic Supply(P2)
Pins Signal Function Cable
7, 8 VL+ Positive input terminal of the logic (Control
& Encoders) power supply VL Logic Supply Cable
9, 18 VL- Negative (-) terminal of logic power supply VL Logic Supply Cable
Table 3: VL Logic Supply Pins and Polarity