ETC SmartFade ML v3.0.1 - Manual (Page 63)

3
Program 55
Memories
Every intensity and device setting, including effects, can be stored to a memory for
playback.
There are 12 fader pages with 24 memory faders in each page. This provides a possible
total of 288 memories. A recorded memory is indicated in red. The bump button lights up
at full if the fader is above zero, contributing to the light output.
To select Memories mode for the faders press MEMS.
The current fader page 1-12 is indicated in the bump buttons during a second when MEMS
is pressed. You can hold MEMS to verify this and to change fader page.
Record a Memory
Set up a look you want to record, including effects. You have two recording choices:
• Record All: records the complete output exactly as it is.
• Record Selected: Records selected devices. Parameter types can be masked. All
intensity channels with a level above zero% will be recorded.
Record All
Test Memory
Press CLEAR four times to clear all intensities. Select MEMS mode and move the fader up.
The same look you recorded should appear on stage. The light in the bump button of the
fader will be dimmed to show that it has content.
Action Console Feedback
1. Activate record all Buttons that can record in this mode will blink
at full. If there is a memory stored already,
this button is dimmed (press CLEAR to exit).
2. If needed, change page ... If needed, hold MEMS and press a bump
button 1-24 to change page.
3. Select fader ... The moment the bump button is pressed, the
memory is stored and the console will auto-
matically return to it’s previous fader mode.
Press UNDO to undo this recording.
MEMS
REC
ALL
MEMS 1 24
1 24