Restore rack defaults – ETC CEM3 v1.5.1 User Manual
Page 51
3
Common Tasks
45
Restore Rack Defaults
Restoring rack defaults is a fast way to completely reset all rack settings back to their
original state. This feature is only intended for users with touring or portable racks
where a complete reset is a common requirement.
Restoring defaults on an installed rack is not recommended unless you are expressly told
to do so by ETC Technical Services.
To restore the factory defaults to your CEM3:
Step 1:
Save a backup of the rack configuration (see
Saving Configurations, page 33
Step 2:
Press and hold [Setup].
Step 3:
Tap [Reset], found in the upper left corner of the CEM3 interface.
Step 4:
Continue holding [Setup] until the “Deep Clear” screen appears.
Step 5:
Select “Yes” to clear all rack settings and restore the factory defaults.
Select “No” to abort.
C A U T I O N :
Restoring rack defaults will erase all rack data. Do not perform this procedure
unless you absolutely intend to restore the rack back to its original factory settings.