ETC CEM3 v1.5.1 - Manual (Page 56)

50 CEM3 User Manual
Set Levels
This page allows you to set and release levels
for any circuit in the rack.
You can use the displayed keypad or a
connected keyboard to input commands into
the green command window.
Once the command line reaches complete
syntax it will be automatically entered as
signified by a “*” at the end of the command
line.
• Select the desired space using the
“Select Space” field at top (if applicable).
• Use “and” and “thru” to select multiple
circuits or ranges of circuits.
• Use “A/B” to specify any dimmer doubled
circuits (if applicable).
• Use “rel” to release channels.
• Use “Release All” to release all current
levels.
• Use “Previous” and “Next” to cycle
through successive channels.
• “Clear” clears the command line.
Setup
This page allows you to alter the “Control Mode” or “Curve” for any circuit in the rack. Click
“Apply Changes” when you have completed all the desired changes.
Files
This page allows you to upload CEM3 firmware or configurations as well as download the
current rack configuration.
To upload a file:
Step 1: First select the file type (Configuration or Firmware) by clicking the appropriate
box at top.
Step 2: Use the “Browse” button to navigate to the desired file on your connected device.
Step 3: Once the file is selected, click “Begin Upload”.
Set Levels Page