EZWatch Pro 3.0 User Manual
Page 28
28
5-2-2. Witness DX Pro System Setup
To change the default parameters of Witness DX Pro, please go to “Start”, “Programs”,
“Witness DX Pro” then select “Set up video parameters”. Follow the instructions below:
z
Set up showing Location and Watermark
Click Set up Stamp as the above picture on the right side; please select Location or Watermark
+ Location. If select Location then only location will be displayed when you enable Stamp as
shown on Fig. 6-2, otherwise both Location & Watermark will be shown.
z
Set up system parameters for single camera
Use mouse to double-click the camera you wish to modify and you will see picture Fig. 5-9.
Close Camera will shut off the camera. Use this function when the camera is not in use.
Note : Please ensure the “Close camera” box is selected, if the video port does not have a
camera connected.
Default will reset parameters to their factory settings.
Video system is for selecting your video system. You can choose between NTSC/PAL.
WARNING: Each country’s Video System is different. North America generally has NTSC
and European countries usually use PAL. Australia and New Zealand use PAL.
Video screen will be in black/white or shaky if the video system is set incorrectly.