EZWatch Pro 3.0 - Manual (Page 71)

71
6-16. How to Trigger Speed Dome Camera
Enabling this option will allow you to configure Speed Dome camera settings upon notification.
To configure Speed Dome camera user could consult the chapter of “Notification”, “Video Loss”,
“Set up Emergency Call”, and “Set up NC-320AM-I sensor”. This function allows user to
preset multiple positions and have cameras move to preset positions when speed dome is trigger.
Speed dome also can move to preset positions when trigger is over. Please refer chapter 6-4.
Follow these steps to preset position:
Duration of trigger
Step 1. Select a specific speed dome camera. At the top of the window.
Step 2. Select preset position where you wish it to move to when triggered. To configure the pre
setting position of Speed Dome camera, user could consult the chapter of NetCom
module operation manual.
Step 3. Click the “Add” to the right to save your settings.
Step 4. Repeat step 1~3 to add one more preset position.
Similarly in the lower part of the window, you can select where you want the camera to go after
triggering has stopped.