HYDAC HMG 3000 - Manual (Page 28)

HMG 3000 Page 28
Edition 11/2007 - V02 R01-S02 Stock no.: 669712
The screenshots at the right show the
measured values of four sensors when
selecting the 2 display panels rendering
option and activating Min/Max display.
Consequently, the display only shows the
measured values of two sensors at a time.
The arrow keys
( ↑ ) and ( ↓ ) enable you to
access the measured values of the other two
sensors.
In order to display the measured values of
4 sensors
simultaneously, you need to
select the 2x2 display panels option (cf.
screenshot).
In the third line of the Display Settings
menu there is a Yes/No option next to Show
progress bar
. Yes causes the progress bar
to be shown in the measured value display.
The appearance of the display may vary
according to what settings have been made
for rendering the measured values.
The overall width of the respective progress
bar corresponds to 0% – 100% of the
measurement range. The progress bar
shows the position of the current measured
value in the overall measurement range.
Showing the Min/Max values causes the
display to be altered. The current measured
value is now shown by a dot and the length
of the progress bar shows the range from
Min to Max. No causes the progress bar to
be switched off.
Back takes you back to the Settings menu.