HYDAC HMG 3000 - Manual (Page 32)

HMG 3000 Page 32
Edition 11/2007 - V02 R01-S02 Stock no.: 669712
Note:
Automatic conversion of measured values
to the selected unit of measurement
doesn't work unless
Automatic detection
(HSI)
mode is selected under Settings –
Measurement Channel Settings
.
Select the unit of measurement to be
changed, followed by OK. Select the new
unit of measurement desired from the drop-
down list via OK.
In the list of measurement channels, the
measurement range for this channel is now
shown in 0 – 1450 psi instead of in 0 –
100 bar, for example.
In the current measured values display the
measured values show psi readings (listed
after the channel or sensor designation).
PC Link
The HMGWIN 3000 and CMWIN software
enables you to make online measurements
and settings in the HMG 3000, in addition to
further processing, archiving, documenting
and updating them. Data transfer generally
takes place via the USB port.
You can also transfer data to the PC via the
HMG's serial port. To do this, select the
RS232(COM)
setting along with the requisite
baud rate.