JULABO FW95-SL Ultra-Low Refrigerated Circulators - Manual (Page 87)

HL, SL
87
Command Parameter Response of circulator
out_mode_05 1 Start the unit.
out_mode_08 0 Set the control dynamics - aperiodic
out_mode_08 1 Set the control dynamics - standard
out_sp_00 xxx.xx Set working temperature. “Setpoint 1”
out_sp_01 xxx.xx Set working temperature. “Setpoint 2”
out_sp_02 xxx.xx Set working temperature. “Setpoint 3”
out_sp_03 xxx.xx Set high temperature warning limit “OverTemp”
out_sp_04 xxx.xx Set low temperature warning limit “SubTemp”
out_sp_06 xxx.xx Set manipulated variable for heater via serial interface
-100 ... +100 [%]
out_sp_07 x Set the pump pressure stage. (1 ... 4)
out_par_04 x.x CoSpeed for external control 0 ... 5.0.
out_par_06 xxx Xp control parameter of the internal controller. 0.1 ... 99.9
out_par_07 xxx Tn control parameter of the internal controller. 3 ... 9999
out_par_08 xxx Tv control parameter of the internal controller. 0 ... 999
out_par_09 xxx Xp control parameter of the cascade controller. 0.1 ... 99.9
out_par_10 xxx Proportional share of the cascade controller. 1 ... 99.9
out_par_11 xxx Tn control parameter of the cascade controller. 3 ... 9999
out_par_12 xxx Tv control parameter of the cascade controller. 0 ... 999
out_par_13 xxx Maximum internal temperature of the cascade controller.
out_par_14 xxx Minimum internal temperature of the cascade controller.
out_par_15 xxx Band limit (upper) 0 ... 200 °C
out_par_16 xxx Band limit (lower) 0 ... 200 °C
out_hil_00 -xxx Set the desired maximum cooling power (0% to 100%).
Note: Enter the value with a preceding negative sign!
This setting is meaningful only for FP cooling machines.
out_hil_01 xxx Set the desired maximum heating power (10% to 100%).
in commands: Asking for parameters or temperature values to be displayed.
Command Parameter Response of circulator
version None Version number of the software (V X.xx)
status none Status message, error message (see page 89)