JULABO FW95-SL Ultra-Low Refrigerated Circulators - Manual (Page 88)

Remote control
88
Command Parameter Response of circulator
in_pv_00 none Current bath temperature.
in_pv_01 none Heating power being used (%).
in_pv_02 none Temperature value registered by the external Pt100 sensor.
in_pv_03 none Temperature value registered by the safety sensor.
in_pv_04 none Setpoint temperature (“SafeTemp”) of the excess
temperature protection
in_sp_00 none Working temperature “Setpoint 1”
in_sp_01 none Working temperature “Setpoint 2”
in_sp_02 none Working temperature “Setpoint 3”
in_sp_03 none High temperature warning limit “OverTemp”
in_sp_04 none Low temperature warning limit “SubTemp”
in_sp_05 none Setpoint temperature of the external programmer
(REG+E-PROG).
in_sp_06 none Temperature indication in °C or °F
in_sp_07 none 1. Adjusted pump stage in the -OFF- condition.
2. Pump stage corresponding to the effective rotational
speed after start.
in_sp_08 none Value of a flow rate sensor connected to the E-Prog input
in_sp_09 none Value of a pressure sensor connected to the E-Prog input
in_par_00 none Temperature difference between working sensor and safety
sensor
in_par_01 none Te - Time constant of the external bath.
in_par_02 none Si - Internal slope
in_par_03 none Ti - Time constant of the internal bath.
in_par_04 none CoSpeed - Band limit (max. difference between the
temperatures in the internal bath and external system).
in_par_05 none Factor pk/ph0:
Ratio of max. cooling capacity to max. heating capacity
in_par_06 none Xp control parameter of the internal controller.
in_par_07 none Tn control parameter of the internal controller.
in_par_08 none Tv control parameter of the internal controller.
in_par_09 none Xp control parameter of the cascade controller.
in_par_10 none Proportional share of the cascade controller.
in_par_11 none Tn control parameter of the cascade controller.
in_par_12 none Tv control parameter of the cascade controller.
in_par_13 none Adjusted maximum internal temperature of the cascade
controller.
in_par_14 none Adjusted minimum internal temperature of the cascade
controller.
in_par_15 none Band limit (upper)
in_par_16 none Band limit (lower)