Lenze E70ACxS Application Sample i700 (PLC Designer v3) - Manual (Page 18)

Opening the Application Sample
18
Lenze · Servo Inverter i700 | Application Sample · DMS 1.0 EN - 09/2012 - TD11
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6 Opening the Application Sample
The Application Sample includes a sample program with three axes and a predefined visualisation.
General procedure
The main steps are presented in the table below:
The commissioning steps in detail
The following section provides a detailed description of every commissioning step.
Please follow the instructions below carefully to commission your automation system.
Step Activity
1st  Creating a new project - opening the Application Sample ( 19)
2nd  Updating the Controller in the project (optional) ( 19)
3rd  Going online ( 20)
4th  Loading and starting the PLC program ( 20)
5th  Getting started - operating the Application Sample ( 22)

Further information about the parameterisation and configuration of the is
provided in the following communication manuals:
• "Controller-based Automation" EtherCAT - commissioning & configuration