Lenze E70ACxS Application Sample i700 (PLC Designer v3) - Manual (Page 20)

Opening the Application Sample
Going online
20
Lenze · Servo Inverter i700 | Application Sample · DMS 1.0 EN - 09/2012 - TD11
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.3 Going online
To establish an online connection to the Controller, the communication settings (Set Active Path)
must be adapted first.  Setting up communication to the Controller ( 9)
6.3.1 Transferring the project to the control system - "logging in"
The "Login" command transfers the PLC program to the Controller.
• Transfer the project to the Controller by "logging in" to the control system:
Menu command Online Login
6.4 Loading and starting the PLC program
• Select the OnlineLoad menu command to load the PLC program to the Controller.
• Select the OnlineRun menu command to start the PLC program.
• Alternatively, execute the DebugRun menu command or press <F5>.

Tip!
If the project is to be loaded automatically after a restart of the device, you can install it
as "Boot project".

How to install the project as boot project:
1. Select the OnlineCreate boot application for L-force Controller menu command.