Lenze E70ACxS Application Sample i700 (PLC Designer v3) - Manual (Page 9)

Lenze · Servo Inverter i700 | Application Sample · DMS 1.0 EN - 09/2012 - TD11
9
Preconditions
System requirements
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3 Preconditions
3.1 System requirements
3.2 Setting up communication to the Controller
• Connect the Engineering PC to the Controller via a network cable. The »PLC Designer« accesses
the Controller via Ethernet.
• Make the IP settings with the »PLC Designer« afterwards.

How to check the communication settings:
1. Go to the Device view and double-click the desired Controller.
2. Make the desired settings on the Communication settings tab.
• Click the Add gateway button to insert a gateway.
Engineering PC Controller
Hardware PC/notebook PLC (Logic) from firmware V3.3
Operating system Windows XP Windows CE
Required Lenze software »PLC Designer« from V3.3 Runtime Software
• Logic
• Motion (for this purpose, the
project data must be updated:
"Update Device")
Further requirements - Bus system
• EtherCAT bus system
• EtherCAT node