MTS Landmark TWX User Manual
Page 133
Advertising
9. Adjust a variable and recalculate.
You can adjust variables after performing test runs to do “what if” analysis or to correct errors (for
example, an incorrect value for diameter).
a) Select a test run. For this example, select Test Run 5.
b) In the Variable Table view, scroll down to Diameter and change the value from 5.000 mm to 6.000
mm. Clicking anywhere else on the screen enters the value and updates any dependent calculated
values.
MTS Landmark Test System Operation | 133
Reviewing, Analyzing, and Reporting Data
Advertising