Rockwell Automation 1395 Digital Reference Adapter Board - Manual (Page 15)

4 Chapter
4-1
Installation
Introduction
This chapter is a detailed procedure for the proper installation and
electrical interconnection of the Digital Reference Adapter Board.
Procedures you will perform in this chapter include:
S Verification of proper unpacking and inspection
S Verification of proper mounting
S Verification of proper wiring
NOTE: Normally all installation and configuration requirements have been
fulfilled when the product is shipped to the user in an integrated factory
controller. This chapter is provided for convenience should it become
necessary to install a Digital Reference Adapter Board into a different or
existing application.
Receiving
It is your responsibility to thoroughly inspect the equipment before
accepting shipment from the freight company. You must take the
responsibility for noting any damage. Do Not accept shipment before
checking all items received against the purchase order, and noting any
missing or damaged items on the freight bill.
If any concealed damage is found later during unpacking, it is your
responsibility to notify the freight agent. Leave the shipping container
intact, and request that the freight agent make a visual inspection of the
shipment.
ESD Precautions
ATTENTION: This Drive contains ESD (Electrostatic
Discharge sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing
or repairing this assembly. Component damage may result if
ESD control procedures are not followed. If you are not
familiar with static control procedures, reference
Allen-Bradley Publication 8000-4.5.2, Guarding against
Electrostatic Damage or any other applicable ESD
protection handbook.
Unpacking & Inspection
Remove all packing material from around the board, including the
anti-static bag. The Digital Reference Adapter Board is a static sensitive
device, and special precautions should be taken while handling the board.
The circuit card can be damaged by Electro-Static Discharge. There is the
possibility you could make contact with an ESD sensitive component
during installation. Therefore, you must be properly grounded. Grounding
should be accomplished with a wrist strap which is connected to an
approved ground.