Rockwell Automation 1395 Digital Reference Adapter Board - Manual (Page 16)

Chapter 4
Installation
4-2
If the board will not be installed when it is unpacked, you must store it in a
clean dry place in the anti-static bag. The storage temperature must be
between 0
°
C (32
°
F) and +60
°
C (140
°
F) with a maximum humidity of 95%
non-condensing, to guard against damage to temperature sensitive
components.
Mounting
On 1 – 100 HP 230V and 2 – 200 HP 460V the Digital Reference Adapter
Board is mounted on the front of the the swing out panel. Two possible
adapter board mounting positions are provided. Depending on the port that
the board will be connected to, it must be mounted in either Port A or Port
B. When looking at the mounting positions from the front, the right
position corresponds to Port B and the left to Port A.
After determining which port the Digital Reference Adapter Board will be
connected to, mount the board using the five panel screws & one phillips
head screw (Figure 4.1 illustrates the Digital Ref Board in Port A of a
1 – 200 HP drive).
On 125 – 300HP 230V and 250 – 600HP 460V drives, the Digital
Reference Adapter board is mounted on a swing out panel below the Unit
Power Supply near the bottom of the cabinet (
Figure 4.2 ).
Figure 4.1
Digital Reference Adapter Board Location
1 - 60 HP
AB0731A
Digital Reference
Adapter Board