Rockwell Automation 1492-PLTKIT Plotter Kit - User Manual - Manual (Page 35)

Initial Setup 2-19
Installing a Pen in the Pen
Station 1. Turn the power on by pressing the “On” button,
2. Press the “Pen Station open/close” button. This will lower the pen
stations to allow a pen to be placed in the station
3. Follow the pen instructions for use on the 1492-PLOTPEN25 or
1492-PLOTPEN35 box by: assembling the pen point to ink cartridge,
shaking pen back and forth to activate ink.
4. Insert pen into pen station. The default pen station is #1 (closest to
user.)
5. Press the “Pen Station open/close” button. This will close the pen
station, sealing it in place. You are now ready to plot.
Removing a Pen from the Pen Station
1. Press the “Pen Station open/close” button. This will open the pen
stations to allow a pen to be removed.
2. Remove the pen from the pen station. Place the cap on the pen.
3. Press the “Pen Station open/close” button. This will close the pen
station.
4. Turn the power off by pressing the “Off ” button.
IMPORTANT
It is important only the 1492-PLOTPEN25 or
1492-PLOTPEN35 pens be installed in the pen station.
Use of a different pen may result in damage to the pen or
plotter.