Rockwell Automation 1492-PLTKIT Plotter Kit - User Manual - Manual (Page 41)

Initial Setup 2-25
create specific settings for that card. If you are satisfied with your calibration,
move onto the “Plotting” section.
1. Go to File→ Print→ Calibration and select “Adjust Marker Type”
2. The following screen will appear, verify that the plotter is selected under
“Options”
3. Use the Offset X and Offset Y values to adjust the single cards
calibration
Increase Offset X: Text moves down
Decrease Offset X: Text moves up
Increase Offset Y: Text moves left
Decrease Offset Y: Text moves right
Note: Suggested increment of change: 0.5mm
➋
TIP