Rockwell Automation 1492-PLTKIT Plotter Kit - User Manual - Manual (Page 38)

2-22 Initial Setup
Printing/Plotting
Before plotting a card, the card must be calibrated and mapped to the
plotter.
Mapping to Plotter: 1. After you have filled out your card as desired, go to File? Print
2. Select the Plotter (1492-PLTKIT Series E) in the “Printer” pull down
menu
3. Click “Map” on the print screen. When the following pop up appears,
select the plotter and click “OK”
Note: Each time a new card is selected it will need to be mapped to the
plotter