Rockwell Automation 1336T PLC Comm. Adapter, Series B, FRN 2.xx-3.xx - Manual (Page 101)

6–11
Publication 1336 FORCE–5.13 –– September, 1998
The remainder of this chapter describes the parameters associated
with the PLC Communications Adapter Board. For parameters not
listed in this section, refer to the parameter descriptions in your 1336
FORCE user manual.
Parameter descriptions adhere to the following conventions.
Par
# [Parameter Name]
Parameter description.
Parameter Number ➀ #
Parameter Type ➁ Read Only or Read/Write
Display Units / Drive Units ➃, ➄ User Units / Internal Drive Units
Factory Default ➂ Drive Factory Setting
Minimum Value ➅ Minimum Value Acceptable
Maximum Value ➆ Maximum Value Acceptable
File – Group ➇ File and Group that Parameter Is In
Enums ➈ Values
➀ Parameter Number Each parameter is assigned a number. The
number can be used for process display set up,
fault buffer interpretation, or serial
communications.
➁ Parameter Type Two types of parameters are available:
Read Only The value is changed only by the
drive and is used to monitor
values.
Read/Write The value is changed through
programming. This type can also
be used to monitor a value.
➂ Factory Default This is the value assigned to each parameter at
the factory.
➃ Display Units These are the units that appear on the HIM
display. Two types exist:
ENUMS A language statement pertaining to
the selection made or language
description of bit function.
Engineering Standard units such as: Hz,
seconds, volts, etc.
➄ Drive Units These are internal units used to communicate
through the serial port and to scale values
properly when reading or writing to the drive.
➅ Minimum Value This is the lowest setting possible for the
parameter.
➆ Maximum Value This is the highest setting possible for the
parameter.
➇ File – Group This lists the File and Group where the
parameter is located. A parameter may be listed
in more than one File and Group.
➈ Enums This lists the bit values that you can use and the
associated meanings.
Parameter Conventions