Rockwell Automation 1336T PLC Comm. Adapter, Series B, FRN 2.xx-3.xx - Manual (Page 148)

7–2
Publication 1336 FORCE–5.13 –– September, 1998
In most cases, header word 2 of the drive response contains a
negative value (bit 15 = 1) when a block transfer operation is not
successful. A status word is also usually returned and indicates the
reason for the block transfer failure. The location of the status word
is typically header word 4 in the drive response, but will vary
depending on the message.
The following status word codes are defined:
This
value:
Has the following meaning:
0 No error occurred.
1
The service failed due to an internal reason and the
drive could not perform the request. Some messages
are read only or write only.
2 The requested service is not supported.
3
An invalid value is in block transfer request header
word 2.
4
An invalid value is in block transfer request header
word 3.
5
An invalid value is in block transfer request header
word 4.
6 The data value is out of range.
7
A drive state conflict occurred. The drive is in an
incorrect state to perform the function. The drive
cannot be running when certain functions are
performed.
Block Transfer Status
Word