Rockwell Automation 1500 Modular Protection System Conversion Kit (Bulletin 1406 to Bulletin 825 Plus) - Manual (Page 13)

Installation
Overview
This chapter describes the procedures for the installation of the Bulletin 1406
to Bulletin 825 Plus Conversion Kit within a medium voltage controller.
Installation within other controller types can also be accomplished by following
the principal philosophy of the retrofit described.
This manual is intended for use by personnel trained and
familiar with medium voltage, solid-state power
equipment, and general industrial controls.
Pre-installation
To avoid shock hazards, lock out incoming power before
working on the equipment. Verify with a hot stick or
appropriate voltage measuring device that all circuits are
voltage free. Failure to do so may result in severe burns,
injury or death.
The National Electrical Code (NEC) and/or Canadian
Electrical Code (CEC) or other local codes outline
provisions for safely installing electrical equipment
Failure to follow locally applicable codes can result in
hazards to personnel or a non-compliant installation.
Tools required:
•
Sheet metal cutting tools capable of cutting up to 12 gauge material
• Hand drill, and drill bits
• Screw drivers
• Allen-key wrench set
• Drop sheets or tarp
The following pictures shown are illustrating a common
controller layout. These pictures may not necessarily
illustrate the exact equipment on which this kit is being
installed. The pictures should be used as a general basis
only.
Chapter
4
1500-IN058D-EN-E – June 2013
A T T E N T I O N A T T E N T I O N
A T T E N T I O N A T T E N T I O N
A T T E N T I O N A T T E N T I O N
I M P O R T A N T I M P O R T A N T