Rockwell Automation 1771-IFF/A,D17716.5.116 FAST ANALOG INPUT MODULE - Manual (Page 43)

4-13
Publication 1771Ć6.5.116 - June1996
The front panel of the fast analog input module contains a green
RUN indicator and a red FAULT indicator. At power-up an initial
module self-check occurs. If there is no fault, the red indicator turns
off.
RUN
FAULT
10528ĆI
FAST
ANALOG
(12 BIT)
Green RUN indicator
Red FAULT indicator
The green indicator comes on when the module is powered. It will
flash until the module is programmed. If a fault is found initially or
occurs later, the red fault indicator lights. Possible module fault
causes and corrective action is discussed in Chapter 7,
Troubleshooting.
In this chapter you learned how to install your input module in an
existing programmable controller system and how to wire to the field
wiring arm.
Indicator Lights
Chapter Summary