Rockwell Automation 1771-IFF/A,D17716.5.116 FAST ANALOG INPUT MODULE - Manual (Page 75)

B–3 Programming Examples
Publication 1771Ć6.5.116 - July 1996
1. Press [SHIFT][MODE] to display your ladder diagram on the
industrial terminal.
2. Press DD, 03:0[ENTER] to display the block transfer write file.
The industrial terminal screen should look like Figure B.2. Notice
the highlighted block of zeroes. This highlighted block is the cursor.
It should be in the same place as it appears in Figure B.2. If it is not,
you can move it to the desired position with the cursor control keys.
Once you have the highlighted cursor in the right place as shown
above, you can go on
to step 3.
Figure B.2
Write Block Transfer for a PLCĆ3 Processor
00000000
00000000 00000000
00000000
00000000
00000000
00000000 00000000
00000000 00000000
00000000 00000000
00000000 00000000
00000000 00000000
000000
000004
000010
000014
000020
WORD
START Ć W0003 : 0000
DATA MONITOR $ W0310Ć [ ]
PROG : I/O OFF : NO FORCES : NO EDITS : RUNG # [RM000000 : MEM PORT OFF
00000000 00000000 00000000 00000000
3. Enter the data corresponding to your bit selection in word 0
through 4.
4. When you have entered your data, press [ENTER]. If you make a
mistake, make sure the cursor is over the word you desire to
change. Enter the correct data and press [ENTER].
5. Press [CANCEL COMMAND]. This returns you to the ladder
diagram.