Rockwell Automation 1732E-IR4IM12R ArmorBlock Dual-Port EtherNet/IP 4-Point Thermocouple and RTD - Manual (Page 28)

20 Rockwell Automation Publication 1732E-UM004A-EN-E - July 2012
Chapter 3 Configure Your Thermocouple and RTD Input Modules with RSLogix 5000 Software
Note that we have used the following properties in this example:
To add the 1732E-IR4IM12R RTD module, follow the same steps. After
adding the modules to your project, the I/O Configuration tree should
appear as follows:
This example uses default Module Definition and configuration
properties. To edit your configuration, see
Edit Your Module
Configuration on page 21 .
Download the Program to
Your Controller After you write configuration for your module, the module does not use this
configuration until you download it to the owner-controller. The download
transfers the entire program to the controller, overwriting any existing program.
Download module configuration as shown below:
Depending on your application, a variety of RSLogix 5000 software screens may
appear to choose a path to your ControlLogix controller and to verify the
download. Navigate those screens as best fits your application.
This completes the download process.
Field Name Value
Name TEST_1732EIT4IM12R
IP address 192.168.1.3
Electronic keying Compatible Module
Revision 1.1
Connection Input Only
A. Click here to see the
pull-down menu.
B. Click download.