Introduction, Ppendix – Rockwell Automation GV3000/SE AC Drive Ver. 6.06 Hdwe Ref., Installation, and Troubleshooting Manual User Manual
Page 109
Compliance with Electromagnetic Compatibility Standards
C-1
A
PPENDIX
C
Compliance with Electromagnetic
Compatibility Standards
C.1 Introduction
This appendix provides information on the GV3000/SE drive’s compliance with
European community electromagnetic compatibility standards and covers the
following:
•
requirements for standards compliance
•
guidelines on installing the AC Mains Filter
•
instructions on how the drive must be wired.
The GV3000/SE drives listed on the Declaration of Conformity (DOC) and in table C.1
have been tested and are in compliance with the following standards when installed
with the appropriate AC Mains Filter:
•
EN50081-1 (1992)
Electromagnetic compatibility - Generic emission standard
Part 1: Residential, commercial, and light industrial
•
EN50081-2 (1992)
Electromagnetic compatibility - Generic emission standard
Part 2: Industrial
•
EN50082-1 (1992)
Electromagnetic compatibility - Generic immunity standard
Part 1: Residential, commercial, and light industrial
•
EN50082-2 (1995)
Electromagnetic compatibility - Generic immunity standard
Part 2: Industrial
Note that the conformity of the GV3000/SE drive to the above standards does not
guarantee that the entire installation will be in conformance.
Copies of the Declaration of Conformity (DOC) may be obtained by contacting the
Rockwell AutoFax service at 440-646-7777.