Compliance requirements, Installing the ac mains filters, C.2 compliance requirements – Rockwell Automation GV3000/SE AC Drive Ver. 6.06 Hdwe Ref., Installation, and Troubleshooting Manual User Manual
Page 110: C.3 installing the ac mains filters
C-2
GV3000/SE AC Drive Hardware Reference, Version 6.06
C.2 Compliance Requirements
In order for the GV3000/SE drive to conform to the standards listed in section C.1, the
drive must:
•
be specified by model number on the DOC.
•
have a CE mark. This mark is found on the drive’s certification label.
•
include an AC Mains Filter. See section C.3 for information on installing the filter.
•
be installed according to the instructions in this appendix.
Note that when using 25-60HP GV3000/SE drives, a special cover is required. The
model number of the GV3000 cover kit is M/N 2CK4160. Follow the instructions
provided with the kit when replacing the cover. The instructions in this appendix
assume that the drive has the correct cover on it.
Contact Reliance Electric for assistance if your application requires CE-certification
when using 200-400HP GV3000/SE drives.
C.3 Installing the AC Mains Filters
The following sections describe how to identify and install the AC Mains Filters. These
filters have been designed to limit the conducted electromagnetic emissions to the AC
power mains from the GV3000/SE drives.
Table C.1 identifies the GV3000/SE drives that are in conformance with the standards
listed in section C.0 and their corresponding AC Mains Filters. Verify that you have the
correct AC Mains Filter for your application. The information provided in this appendix
applies to all the AC Mains Filters listed in table C.1 unless otherwise noted.