Use a sensor mounting bracket – Rockwell Automation 1442 Eddy Current Probe System User Manual
Page 27
Rockwell Automation Publication ICM-UM004C-EN-E - February 2014
27
Installation
Chapter 1
Use a Sensor Mounting Bracket
If you need a mounting bracket for the sensor, construct your own mounting
bracket. The mounting bracket can be readily machined at your site. The bracket
must provide a stable, secure, platform that satisfies the conditions described in
the
Sensor Installation Environment on page 13
.
When using a sensor mounting bracket, use the following steps to install the
sensor.
1. Attach the sensor mounting bracket to the mount (body), and temporarily
attach with bolts.
Insert the sensor into the sensor mounting brackets screw hole, and adjust
the gap between the sensor top face and the target.
Refer to Set Gap Voltage on page 35
.
2. Tighten the bolts further, and affix the sensor mounting bracket.
3. Retighten the lock nut gain at the specified torque.