CommScope ATC200-LITE-USB - Manual (Page 106)

Section 16–Changing the Beamwidth (Fan)-Single SmartBeam™ ATC200-LITE-USB Teletilt ® RET System
16-2 October 2014 Bulletin 639536 • Revision L
4. The Set Actuator Position screen will appear (Figure 16-2).
Note, all parameters that can be configured are displayed on this screen. This information may
be used as a reference to help determine the new Beamwidth (fan) setting. However, configura-
tion items cannot be changed from this screen. All changes to configuration items must be done
with the Configuration screen as discussed in Section 10.
5. Enter the new beamwidth value in the New BW/Fan text entry field to change the Beamwidth
(fan). Note that the allowed BW/Pan range is displayed in the Min BW/Fan and Max BW/Fan
fields in the top part of the screen. Any degree of beamwidth within this range may be entered.
Values may be entered as whole degrees (Figure 16-2).
Examples: Five degrees Beamwidth (Fan) may be entered as 5 or 5.0
Figure 16-2. Configuring New Beamwidth (Fan) Setting
1. Enter a new Beamwidth (Fan).
Refer to the Min. BW/Fan and Max. BW/Fan values to ensure that the
new pan azimuth entered is within the range for the antenna
model. Values may be entered as whole degrees.
Progress
Display.