CommScope ATC200-LITE-USB - Manual (Page 8)

Table of Contents ATC200-LITE-USB Teletilt ® RET System
ii October 2014 Bulletin 639536 • Revision L vi October 2014 Bulletin 639536 • Revision L
Part 4 – Operating Instructions for Standard Antennas
with Attached Actuators
Section 5 Actuator Protocol Mode Switching....................................................5-1
5.0 Protocol Mode switching for ATM3 devices .............................................................. 5-1
5.0.1 Using AISG Reset Option Tools ............................................................................... 5-1
5.0.2 Switching a Single ATM200-002 to Ericsson Protocol .............................................. 5-4
5.1 Protocol Mode switching for AccuRET devices ........................................................ 5-6
Section 6 Device Configuration ........................................................................6-1
Section 7 Changing the Electrical Downtilt on a Single Antenna ......................7-1
Section 8 Changing the Electrical Downtilt on a Group of Antennas ................8-1
Part 5 – Operating Instructions for Antennas with Multiple
Integrated Actuators
Section 9 Switching Operating Modes for Multiple Integrated Actuators ........9-1
Section 10 Device Configuration for Antennas with Multiple Integrated
Actuators .....................................................................................10-1
Section 11 Adjusting the Electrical Downtilt on a Single Antenna Equipped
with Multiple Integrated Actuators ...............................................11-1
Section 12 Adjusting the Electrical Downtilt on a Group of Antennas Equipped
with Multiple Integrated Actuators ...............................................12-1
Part 6 – Operating Instructions for SmartBeam TM Antennas
Section 13 Device Configuration with SmartBeam™ Antennas ......................13-1
Section 14 Changing the Electrical Downtilt on a Single SmartBeam™
Antenna
........................................................................................14-1
Section 15 Changing the Boresight (Pan) on a Single SmartBeam™
Antenna
........................................................................................15-1
Section 16 Changing the Beamwidth (Fan) on a Single SmartBeam TM ..................
Antenna ........................................................................................16-1
Section 17 Changing the Electrical Downtilt on a Group of SmartBeam™
Antennas
.......................................................................................17-1