CommScope ATC200-LITE-USB - Manual (Page 61)

ATC200-LITE-USB Teletilt ® RET System Section 6–Device Configuration
Bulletin 639536 • Revision L October 2014 6-4
this field is not required, if no installation date has been saved on the actuator the program
will suggest the current date as the default. If the current date is used, it will be saved on the
actuator when the Configure button is activated. Alternately, the suggested date may be
erased and a new date entered, or the field may be left blank. When a date is entered, it
must be formatted as MM/DD/YY as shown in Figure 6-2 (A forward slash character placed
between the month and day and a forward slash character placed between the day and
year) i.e., July 7, 2008 would be typed as 07/07/08.
• The installer’s ID must be 1 to 5 characters in length with any combination of letters
and
numbers.
• Values specified for the frequency band, sector, technology, location, and mechanical tilt are
used for reference only and have no direct affect upon the actuator/antenna that is being
configured.
• Frequency band (AISG 1.1)/Operating Band (AISG 2.0) value can have multiple values set.
Click on the drop down arrow in the list to open the multi selection list. Make selection by click-
ing on the check box for the relevant frequency. Click outside the list or press ESC key to close
the list (Figure 6-3).
Figure 6-3. Multiple Frequency/Operating Band Selection
8. After verifying the accuracy of all fields, click Configure. Alternately, the user may go back and
edit/change any of the selections made or click the Cancel button to quit this process without
making any changes to the actuator’s current configuration.
9. After the Configure button has been activated, the user will be prompted to confirm changes
to the actuator are to be applied. Click Yes to proceed with the changes, or click No to return to
the configuration screen (Figure 6-4).
When proceeding to make changes, the selected settings will be sent to the actuator and stored
there. The main screen will change the status of this device to Configuring to indicate that new
settings are being sent to the actuator. The status icon is yellow while the configuration data is
changing.
1. Click to open the
down list.
2. Click on check box to
frequencies.
selected frequency
band names.
3. Click outside the list or