CommScope ATC200-LITE-USB - Manual (Page 53)

ATC200-LITE-USB Teletilt ® RET System Section 5–Actuator Protocol Mode Switching
Bulletin 639536 • Revision L October 2014 5-3
Notes:
• Communication is temporarily interrupted to the AISG devices on the RET system when an
AISG 2.0 Reset command is sent. This interruption is identified by a red indicator next to the
device in the Device Information window (Figure 5-3).
• Operating screens will vary somewhat for devices operating in AISG 1.1 to those operating
in ASIG 2.0, due to the differences in the two AISG protocols. Where possible, all AISG
devices should operate in the same AISG mode to provide the best operating conditions.
Figure 5-3. Resetting All ATM200-002 Actuators to AISG 2.0.
occur while the device resets.