DJI Naza-M Lite - Manual (Page 26)

©2014 DJI. All Rights Reserved. 26
Home point
Usually
Home point
In home lock
Before using this function, you have to choose a 2 or 3 positions switch on your transmitter as IOC switch. Then
connect a wire to the correct channel of receiver to the X2 port of MC. At each switch position, use end-point fine
tuning on your transmitter, move the slider of channel X2 to Home Lock, Course Lock, OFF to turn the corresponding
area blue respectively.
Tips:
 For 3-position switch:
Position-1 is OFF; Position-2 is Course Lock; Position-3 is Home Lock.
 For 2-position switch:
Position -1 is OFF; Position-2 is Course Lock. Or Position -1 is OFF; Position-2 is Home Lock.
 If you use S-Bus/PPM receiver, the default channel connection is shown in TX Monitor – Receiver
Type section. Then you only need to assign a 2 or 3-position switch of your transmitter to the 6 th
channel.
Notices:
Do NOT set a 2-position switch as: Position-1 is Course Lock; Position-2 is Home Lock.
Course Lock Usage:
During the same flight:
STEP1: Record STEP2: Open STEP3: Close STEP4: Re-open
Nose direction; Forward direction
STEP1: Record forward direction: There are two ways: Manually; Automatically:
a) Automatically: MC will record the current nose direction as forward direction at 30 th second after
you power on the multi-rotor. And LED will blink quickly if recording is successful.
b) Manually: You can slide X2 channel switch between OFF and Course Lock position quickly 3 to 5
times to record current nose direction as new forward direction at any time after you power on
multi-rotor 30 seconds. And LED will blink quickly if recording is successful.
Tx
1 2 3 3 Position
Switch