Matters that need attention – DJI Naza-M Lite User Manual
Page 6
©2014 DJI. All Rights Reserved.
6
Matters That Need Attention
For safety reasons, please pay serious attention to all following items:
1.
For big aircraft that is larger than 650 or with heavy load, WKM is recommended.
2.
When aircraft is set-up with all of the equipment that you are going to use, please ensure the aircraft center
of gravity is on the center Line of the frame, this is for aircraft with its load is in the vertical direction of frames
center.
3.
When MC mounted, try your best to mount the MC at the center of the frame, and do not mount the MC
upside-down. Make sure MC is parallel to the aircraft horizon, so as to prevent the aircraft from drifting in
4.
Make sure the MC ESC ports is pointing to the aircraft nose direction, otherwise serious damage will occur to
your aircraft.
5.
Disconnect ESCs and battery or remove all propellers during firmware upgrade, configuration and system
setup!
6.
You have to reboot MC and redo the TX calibration after you change anything on the RC system.
7.
In the TX Calibration of assistant software:
Throttle: Slide left is craft down, slide right is craft up;
Rudder: Slide left is nose left, slide right is nose right;
Elevator: Slide left is craft back, slide right is craft front;
Aileron: Slide left is craft left, slide right is craft right.
8.
When powering up the Craft, Make sure you turn on the Transmitter switch first, then Plug in the FC Battery
power on multi-rotor before takeoff! After your Flying Session and you want to power down, make sure you
Remove Power to the multi-rotor first, and then switch off the transmitter!
9.
Whether you are using gimbal control in assistant software or not, there is always power output from F1 and
F2 ports. Do not connect these ports to any ESCs which are wired with propellers and motors.
10.
Do NOT set the failed-safe position of throttle under 10% of endpoint.
11.
Throttle stick position should always be higher than 10% from cut-throttle during the flight!
12.
The NAZA-M LITE-M has Low voltage protections! If you are seeing a Red Flashing light, you should land your
multi-rotor ASAP to prevent your multi-rotor from crashing or other harmful consequences!
13.
when using the (Immediately mode) to stop the motors, this is in any control mode, once the motors start and
throttle stick is over 10%, When the throttle stick lowered below 10% the motors will stop immediately .But if
you push the throttle stick over 10% within 5 seconds after motors stop, the Motors will re-start; Combination
Stick Command (CSC) is not needed. If you don’t push throttle stick after motors start in three seconds,
motors will stop automatically.