DJI Naza-M Lite User Manual
Page 7
©2014 DJI. All Rights Reserved.
7
14.
By using Intelligent mode to stop motors, the motors will start or stop immediately when you execute CSC.
During normal flight conditions, you only have pull throttle stick under 10% will not stop the motors in any
control mode. You have to execute CSC to re-start motors if the motors stop during the flight.
15.
Red light quick blinking indicates battery voltage is low, please land ASAP.
16.
Do NOT move any command sticks during system start and self-check! Please contact us if the last four green
blinks are abnormal.
17.
GPS/Compass is sensitive to magnetic interference; you should be as far away from any electronic devices as
possible.
18.
Do not fly in GPS Mode when the signal is not good (red light blinks)!
19.
GPS module is optional (Nonstandard). If you are using the GPS module, please read the Instructions about
GPS matching in indicators; users without the GPS module can skip contents about GPS.
20.
If users set GPS Atti. Mode in Control Mode Switch without connecting to GPS module, the M.C. will switch
GPS Atti. Mode into Atti. Mode automatically, and LED indicator will Blink yellow.
21.
If you are working in the Fail-Safe Mode, with GPS on, the aircraft motors will auto Automatticly shut off when
the craft has landed; without GPS the aircraft will not auto shut off when landed.
22.
The receiver should be installed under the bottom board of center frame, and the head of antenna is downward
without any obstacles, this will help prevent any signal loss during flight and the aircraft will be out of control,
since the Radio signal may be lost by the obstacle.
23.
Make sure all connections are correct and attachment contacts are in good condition before flight.
24.
Keep wireless video transmission equipment a distance away from the main controller (>25cm), to prevent the
main controller from getting any interference from the Wireless Video Transmitter.
25.
If you use a gimbal, please make sure that the working current of the servos should not exceed the power
supply capacity of the VU; otherwise, it may cause the VU safeguard and lead to the main controller reboot.
Refer to the Specification section in the Appendix to get more VU parameters.