Metrohm 760 Sample Changer - Manual (Page 22)

3.4 Configuration Procedure
760 Sample Changer, Introduction
19
HOLD
red blinks
green 5 ∗
The <HOLD> key switches on the stirrer(s). If the <HOLD>
key is kept pressed down the speed increases continuously.
If the <HOLD> key is pressed again the stirrer speed is re-
duced in a similar manner. In this way the stirrer speed can
be set accurately.
START
blinks
<START> accepts the setting. The configuration procedure
is now complete. It can be restarted by pressing <HOLD> in
order to select the method.
STOP
RESET
lights up
The configuration procedure is terminated with <STOP>.
When the green LED is illuminated the sample changer is in
the basic condition and is ready to process a series of sam-
ples.
The individual steps of the configuration procedure:
1
∗ Method selection
2
∗ Setting the working position
3
∗ Setting the rinsing position
4
∗ Setting the shift position
5
∗ Setting the stirrer speed