Metrohm NIRS XDS SmartProbe Analyzer User Manual
Page 30
28
▪▪▪▪▪▪▪
LED Indicators on the Smart Probe Handle
Pass:
The sampled material has passed the ID and Qualification
test (Routine Analysis)
Fail:
The sampled material has failed the ID or qualification Test
(Routine Analysis) This means the material was either not
identified, or was outside of acceptance limits for that
material.
Ready:
The Smart Probe is ready to take a sample scan.
Scan:
Scanning reference or sample.
Enter:
Not used
Ref:
System is ready to scan reference material
Upon initial instrument power-up, the LED indicators will illuminate in a clockwise pattern, for 5
times. This occurs about 25 seconds after power-up. Following this, the “Module” LED illuminates.
This indicates that the instrument has verified the Smart Probe as being present and operating.
When using the Smart Probe, Vision will prompt
the user to pull the trigger to start the scan.
This shows the trigger. A short, decisive squeeze
is all that is needed. As soon as Vision recognizes
the action, the dialog box is removed from the
screen.
The operator will normally wear protective gloves
to meet cGMP regulations. The glove was
omitted in this photo for clarity.