Metrohm 757 VA Computrace - Manual (Page 54)

3 Installation
757 VA Computrace – Hardware
50
3.9.4 Operation of the 813 Compact Autosampler
After installation of the instruments according to sections 3.9.1...3.9.3 sample series
using the 813 Compact Autosampler can be started. Proceed always in the follow-
ing sequence:
1 Switch on instruments
• Switch on Dosimats and 757 VA Computrace Stand.
• Switch on 813 Compact Autosampler and 731 Relay Box.
• Switch on PC.
• Start 757 VA Computrace software (see Software Manual, section 2.2).
2 Load and modify method
• Click on or MAIN WINDOW / Mode / Determination .
• Click on or MAIN WINDOW / Window / Working method specification to
open the WORKING METHOD SPECIFICATIONS window.
• Load the desired method in the
WORKING METHOD SPECIFICATIONS
window.
• If desired, modify the loaded method (details see Software Manual).
3 Load and modify sample table
• Click on or MAIN WINDOW / Window / Sample table to open the SAMPLE
TABLE window.
• Load the desired sample table or edit the current sample table (details
see Software Manual).
4 Place samples on 813 Compact Autosampler
• Transfer the desired sample amount (5...10 mL) into the sample vessels
and place them at the odd positions on the sample rack of the 813 Com-
pact Autosampler.
• For each sample vessel, place a vessel filled with rinsing solution at the
following even position (volume rinsing solution = volume sample solu-
tion).
5 Start determination
• Click on or MAIN WINDOW / Window / Monitor to open the MONITOR
window.
• Start the measurement by clicking the icon in the MAIN WINDOW or
the button in the MONITORING window.
• Press the "START" button on the keypad of the 813 Compact Autosam-
pler.
• Follow the instructions in the appearing message windows.