Metrohm 919 IC Autosampler plus - Manual (Page 27)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
919 IC Autosampler plus
￭￭￭￭￭￭￭￭ 19
Cable connection and driver installation
A driver installation is required in order to ensure that the 919 IC Auto-
sampler plus is recognized by the PC software. To accomplish this, you
must comply with the procedures specified. The following steps are neces-
sary:
1 Installing the software
￭ Insert the PC software installation CD and carry out the installa-
tion program directions.
￭ Exit the program if you have started it after the installation.
2 Establishing the cable connections
￭ Connect all peripheral devices to the instrument, see Chapter 3.8,
page 20 and .
￭ Connect the instrument to the power supply if you have not
already done this.
￭ Connect the instrument to a USB connector (Type A) of your com-
puter (see manual of your computer). The 6.2151.000 cable is
used for this purpose.
6.2151.000
USB 2
USB 1 Contr. MSB 2
Figure 12 Connecting the computer
The instrument is recognized. Depending on the version of the Win-
dows operating system used, the driver installation proceeds differ-
ently afterwards. Either the necessary driver software is installed
automatically or an installation wizard is started.
3 Follow the instructions of the installation wizard.
If problems should occur during installation, contact your company's IT
support team.
NOTE
The plug on the instrument end of the 6.2151.000 controller cable is
protected against accidental disconnection by means of a pull-out pro-
tection feature. If you wish to pull out the plug, you will first need to
pull back the outer plug sleeve marked with arrows.