Metrohm 795 KFT Titrino - Manual (Page 64)

3.2 Remote control commands
795 KFT Titrino
60
&Info
Object Description Input range Reference
& Root
:
├ Info Current data
: ├ .Report Transmission of formatted reports $G 3.2.2.60.
│ ├ .Select Report type configuration, parameters,
│ smpl data, statistics, silo,
│ C-fmla, def, user method,
│ full, short, mplist, curve,
│ scalc full, scalc srt, calc,
│ all, ff ditto
│
├ .Checksums Checksums $G 3.2.2.61.
│ ├ .MPList Checksum of meas.point list read only ditto
│ ├ .ActualMethod Checksum of current method read only ditto
│
├ .DetermData Determination data $G 3.2.2.62.
│ ├ .Write Read/write for several nods ON, OFF
│ ├ .ExV Volume of Exchange/Dosing unit read only/read+write ditto
│ ├ .MPList Measuring point list
│ │ ├ .1 Measuring point 1
│ │ │ ├ .Attribute Attribute read only/read+write ditto
│ │ │ ├ .X X coordinate read only/read+write ditto
│ │ │ ├ .Y Y coordinate read only/read+write ditto
│ │ │ ├ .Z1 Z1 coordinate read only/read+write ditto
│ │ │ ├ .Z2 Z2 coordinate read only/read+write ditto
│ │ │ for each measuring point
│
├ .TitrResults Titration results
│ ├ .RS Calculated results
│ │ ├ .1 1 st result
│ │ │ ├ .Value Value read only 3.2.2.63.
│ │ ├ up to 9 results
│ ├ .EP Endpoint
│ │ ├ .1 1 st result
│ │ │ ├ .V Value read only ditto
│ │ │ ├ .Meas Measured value read only
│ │ │ ├ .Mark without meaning
│ │ ├ up to 9 EP's
│ ├ .Var Variables C4X
│ │ ├ .C40 Start measured value read only/read+write ditto
│ │ ├ .C41 Titration end volume read only/read+write
│ │ ├ .C42 Titration time read only/read+write
│ │ ├ .C43 Volume drift read only/read+write
│ │ ├ .C44 Titration temperature read only/read+write
│ │ ├ .C45 Start volume read only/read+write
│ │ ├ .DTime Time for drift corr.or dosing time read only/read+write